Homesteading Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
7,100 Posts
Install 5-V roof metal by overlapping two raised v's over two raised v's; with your hammer place a 'ding' into the v clostest to the edge of the metal, then puncture the v with a sharpened punch or nail, make a hole just big enought for your final nail (or screw) to enter. NEVER place a nail or screw in the flat area. The ones I installed in 1967 are still there, not leaking yet. Placeing a nail or screw in the center v is an option if you are in a severe wind area.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top