Homesteading Forum banner

Fillet Knife...

898 views 9 replies 5 participants last post by  ||Downhome|| 
#1 ·
Well here is the third Knife I've ever made.

Since I recently accuired 700' of Bandsaw Blade coil stock, and I always head that it makes nice fillet knifes...

Why not?

I need to redo the handle, I showed the pretty side.

Brass I have for pins is a little hard and bent.

Rather then flatten, cracking the other side.

All in all though they do make nice Blades.

I can shave with this one!
 

Attachments

See less See more
1
#5 ·
Really just wants to straighten on its own, give it tweak this or that.

This is new/old blade stock.

As well as being the out side radius.

On a short section not to hard to get her straight.

Just my fingers more or less.

Its only a .032 thick.

I'm pretty impressed!

Got a good bit of bend, it can however keep it , but a flex this way and that straight as can be.
 
#7 ·
I have a order from a face book freind for one of these and a skinner. I asked a bare minimum and he shot it well over ! all I can say is thank you. By the way not offered up here, you need a knife ask Ernie! Wont take orders here.

But I can sell to my facebook family and else where.

by and by thank you all!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top