Homesteading Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
7,100 Posts
Discussion Starter · #5 ·
Not finding anything yet I am going to build my consept of what it should be. I will creat a card table size frame with a sheet metal chute underneath, that will carry off worm and eggs plus casting materials that will fit between 1/4 inch mesh of hardware cloth. On the open top there will be a sliding rectangle frame, which will hold about 2 gallons of mixed materials, that will be shifted and tapped to the end to dislodge the smaller portions of the worm, soil mix through the mesh. Of course I exspect to have to experiment with mesh size.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top