Craftsman Arc Welder Manual Needed

Discussion in 'Shop Talk' started by MN Mom, Jun 4, 2006.

  1. MN Mom

    MN Mom Well-Known Member

    Messages:
    238
    Joined:
    May 19, 2003
    Location:
    a state of confusion...ha ha. MN
    Picked up and old arc welder yesterday at an auction.

    Looking for a manual but SEARS says none available part number 61037.

    All 3 cables need replacing but sears says good luck on those too. I think I can figure out new ones with help of a old welder friend of mine.

    Model CRAFTSMAN AC ARC WELDER 230 AMP. PORTABLE - model 113.20790

    There are 7 cable plug in spots on the front of the welder. 3 top row which from the sears diagram is the pos. side. 4 spots in the bottom row neg. side.

    Jon
     
  2. Ross

    Ross Moderator Staff Member Supporter

    Messages:
    13,086
    Joined:
    May 9, 2002
    Location:
    Ontario
    No harm asking here but try ebay too.
     

  3. ace admirer

    ace admirer Well-Known Member Supporter

    Messages:
    1,875
    Joined:
    Oct 4, 2005
    surplus center might have the male and female (plug and recpt.) that you could use....they use to have some close to the ones on my sears welder.
     
  4. farminghandyman

    farminghandyman Well-Known Member Supporter

    Messages:
    2,466
    Joined:
    Mar 4, 2005
    Location:
    Colorado
    probably a good welding supply shop (like linweld) can put your welder back in to shape, or sell you what you need,

    welding cable is welding cable (yes there is the gage) but that should not be hard to figure out, (what I an trying to say is sears is not special)

    or try here they some one here may know the back ground of the welder, http://www.hobartwelders.com/mboard/