
07/03/11, 03:50 PM
|
|
|
|
Join Date: Feb 2008
Posts: 4,443
|
|
|
How to build a turtle trap: I hope I can explain this so you can build you one.
1. make a square frame out of 2 x 4 studs of about 2 ft. across
2. Glue 1 inch thick strips of stryofoam on one side of the 2 x 4 studs. The styrofoam is used to make the square frame float on top of the pond water.
3. Make a basket out of chicken wire that would surround the square frame and extend down close to 2 feet. Attach this basket to the outside of the square frame.
4. On the inside of the square frame. Hammer finishing nails of about 3 inches long into the sides of the frame. Hammer the nails deep enough so that there is about 1 1/2 inches of the nail sticking out. Space the nails about 1 inch apart all around the inside of the frame.
5. Use fresh chicken scraps such as backbones, neckbones, liver, or fish remains,etc, and place in a bag of somesort and suspend the bag so that it is located about the very center of the square frame.
Anchor the trap about the center of the pond. The turtles will crawl over the top and into the basket. But when they try to crawl out, their shells will get caught on the finishing nails and will keep them in.
I hope the directions make sense.
__________________
r.h. in oklahoma
Raised a country boy, and will die a country boy.
|